A density of approximately 60 g/m2 will provide a shade rate of approximately 25%, and when the density is increased to 215 g/m2, the shade rate can increase to approimately 60%. The amount of shade varies depending on the density of the netting. The netting can also protect the employees by providing shade.
#WHO SHOULD DESIGN A SCAFFOLD FULL#
However, using scaffold netting ensures full coverage rather than just protection where the rails are located. When normal scaffolding is set up, there are guardrails and toe rails which act as barriers to protect the employees from falling. Extra Layer of Fall Protectionįor the employees working on the construction project, it protects the workers by adding an extra layer of fall protection.
Scaffold Netting protects both employees working on the construction project, along with people working around the project. This can be from debris such as dust, heat, rain, and many other hazards. The main objective of scaffold netting is to better protect the workers and the people working around the scaffolding. Scaffold Netting (sometimes called “Debris Netting” or “Construction Safety Netting”) is one of the many tools used in the construction industry when working with scaffolding. As an Amazon Associate I earn from qualifying purchases. The highest part of the scaffold is the uppermost functional component (usually the top guardrail) and does not include any redundant tube above this point.This post may contain affiliate links, we may receive a commission if you make a purchase using these links. Tip: Be aware that the 5m is measured from highest part of the scaffold to the ground. This could be gained through training, qualification, or experience, or a combination of these. The knowledge and skills to carry out a particular task. You’ll also need the right certification, depending on the situation. To set up a scaffold under 5m, you must be what is called a “competent person”. Containment screening is to be provided when required by risk assessments.Įveryone involved in the scaffolding process must have the knowledge and skills to perform the work safely, regardless of the height of the scaffold.
All scaffold platforms have full edge protection including top guardrails (between 900mm min and 1100mm max), mid rails and toe boards. The scaffold platform is decked the full width of the scaffold structure and is no further than 300mm from the work face and if greater, then either inside planks or internal guardrails and toe boards are to be fitted. All prefabricated scaffolds must be erected to the manufacturers' assembly instructions. The scaffold structure is sound, including provision of adequate ties, bracing, outriggers (or rakers) and suspended scaffold suspension rigs. Appropriate access is provided to the scaffold platforms by way of secure ladders, stairs or access directly from the adjacent structure. Mobile scaffolds are to have castors with brakes and should only be used on firm level surfaces. If in doubt seek advice from an engineer. The scaffold has a suitable foundation including sound supporting structure, a steel base plate and if necessary a timber sole-board or bearer. Suspended scaffolds should also be inspected daily by operator. All scaffolds over 5 metres, all suspended and all special scaffolds have a register on site and this is completed and updated at weekly inspections by a certified scaffolder. An information tag is fitted to the scaffold and is completed and updated at weekly inspections (daily for suspended scaffolds). The scaffold is sufficent for the job and fit for its intended purpose. All risks have been identified, assessed and adequately controlled especially those related to falls from heights and protection of workers and public from falling objectsĪ site management representative should inspect the scaffold prior to acceptance and use to ensure:. A copy of the TMP is to be provided to site management A (TMP) Traffic Management Plan (where required) has been submitted to and accepted by the Local Authority. The WorkSafe NZ Notification of Particularly Hazardous Work form has been completed for a scaffold more than 5 metres high and a copy provided to site management. A copy of Scaffolder's Certificate of Competency is to be provided to site management The scaffold is erected by a scaffolder certified for the type of scaffold to be erected. The Safety Plan should be reviewed by site management before commencing work to ensure it specifically includes: The Safety Plan is communicated effectively to staff on site. Emergency procedures are included in the Safety Plan. Erecting a Scaffoldīefore errecting a scaffold, site management must ensure: Scaffolds should only be used once these requirements are met and approval has been given by site management. Health and Safety at Work Act (HSW Act).
0 kommentar(er)
